Table of Contents
Advertisement
WALL CONTROL FUNCTIONS
Starting Your Cooler
The POWER button turns the cooler on and
off.
There are two modes of operation to choose
from, Automatic mode or Manual mode.
When the cooler is turned on, it will start in
the mode of operation it was in when last
turned off.
If your cooler has not been operated for a
while, then when you start it, "Pre Cool
Cycle" may sometimes flash on the display
as shown. This indicates that the water pump
will operated to saturate the cooling pads for
a few minutes before the fan is turned on.
This is to ensure that when the fan starts,
only cool air enters the building.
Automatic Mode
T h e A U T O b u t t o n s w i t c h e s b e t w e e n
Automatic mode and Manual mode. When
" A u t o " i s d i s p l a y e d t h e c o o l e r i s u n d e r
Automatic control and will operate to the
temperature sensed at the wall control.
When the cooler is turned on, it will read the
temperature and set the cooler operation
accordingly. If the temperature increases at
the wall control, then fan speed will increase.
As the temperature decreases the fan speed
will decrease until the cooler turns off.
Press
or
to override the automatic
cooling level setting and adjust your room
temperature.
24
25
ILL1085-A
26
AUTOMATIC MODE DISPLAY
ILL1096-A
17
Hide quick links:
Advertisement
Table of Contents
