System Features - Linear SSD8 Installation Instructions & Owner's Manual

SYSTEM FEATURES

1
2
3
4
1. SPEAKER
Sounds unique sirens for burglary or emergency.
Alarm siren stops automatically after five minutes.
Sounds mode selection gongs and beeps.
Sounds keyclicks as keypad keys are pressed.
Sounds beeps during exit and entry time delays in the Away Mode.
Sounds "ding-dong" in Chime Mode when protected door or window opens.
Console has connections for an external speaker.
2. MODE INDICATORS
Displays which mode the system is currently in.
During AC power failures, the active mode indicator will blink after 30 seconds.
The Away Mode indicator will blink during the exit delay time.
3. MODE BUTTONS
Used to change the operating mode of the Console.
From the Off Mode, pressing [CHIME], [HOME], or [AWAY] for 2 seconds will arm the system to that mode.
From Chime Mode, pressing [HOME] or [AWAY] for 2 seconds will arm the system to that mode.
To disarm the system, your secret code must be entered on the keypad first, then pressing [OFF] or [CHIME]
will switch the system to that mode.
4. KEYPAD
Used to enter your secret code before disarming the system.
Used during system programming to select sensor location numbers or to change your secret code.
A beep sounds from the speaker as each key is pressed.
The [ ] key resets the keypad in case the wrong keys are pressed.
5. SENSOR STATUS INDICATORS
Display the status of each of the system's wireless sensors.
When a protected door or window is open, its sensor status indicator will light.
If a wireless sensor has a low battery, its sensor status indicator will briefly flash until the low battery is replaced.
If an alarm is triggered by a sensor, its sensor status indicator will slowly blink on and off until the system's
mode is changed twice.
Used during programming to show if sensor location is empty or full.
Area next to the indicators allows labeling each sensor location with the pre-printed labels supplied.
6. WALL MOUNTING BRACKET
Snaps onto the Console for mounting the unit on the wall.
Built-in wire holder to store excess AC adapter wire.
7. VOICE DIALER JACK
For connection to the optional telephone voice dialer.
8. ANTENNA SCREW
Used to secure the whip antenna in place.
9. BATTERY ACCESS DOOR
Provides access to the location for the two backup batteries.
Two 9-volt alkaline batteries are recommended to provide uninterrupted operation during AC power loss.
10. VOLUME CONTROL
Controls the volume of the system's advisory beeps, gongs, and tones.
Does not affect the volume of the system's sirens.
2
8
7
5
6
9
10