Resetting The Console; Fcc Notes - Linear SSD8 Installation Instructions & Owner's Manual

RESETTING THE CONSOLE

UN-PLUG
AC ADAPTER
&
PRESS AND HOLD [OFF]
AND [ ] WHILE PLUGGING
IN AC ADAPTER

FCC NOTES

Radio controls provide a reliable communications link and fill an important need in portable wireless
signalling. However, there are some limitations which must be observed.
For U.S. installations only: The radios are required to comply with FCC Rules and Regulations
as Part 15 devices. As such, they have limited transmitter power and therefore limited range.
A receiver cannot respond to more than one transmitted signal at a time and may be blocked
by radio signals that occur on or near their operating frequencies, regardless of code settings.
Changes or modifications to the device may void FCC compliance.
Infrequently used radio links should be tested regularly to protect against undetected
interference or fault.
A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale
distributor or dealer, and these facts should be communicated to the ultimate users.
This equipment generates and uses radio frequency energy and if not installed and used properly,
that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and
television reception. It has been type tested and found to comply with the limits for a Class B digital
device in accordance with Part 15 of FCC Rules, which are designed to provide reasonable
protection against such interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause interference to
radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Relocate the Console away from the TV/radio receiver.
Plug the Console into a different wall outlet so that the Console is on a different branch circuit.
Re-orient the TV/radio antenna.
If necessary, the user should consult the dealer or an experienced radio/television technician
for additional suggestions.
DISCONNECT THE
BACKUP BATTERIES
(IF INSTALLED)
If you forget your secret code the Console can be
reset.
NOTE: Resetting the Console will erase all of the
wireless sensors and the secret code from the
system's memory. After resetting, each sensor will
need to be added back into the system.
To reset the Console:
1. Disconnect the 9-volt backup batteries (if installed).
2. Unplug the AC adapter.
3. Press and hold the [OFF] and [ ] keys while
plugging in the AC adapter. A beep will sound and
the system will assume the Off Mode.
4. Create your secret code (see Apply Power &
Create Your Secret Code) and re-program each of
the wireless sensors (see Adding and Removing
Sensors).
13