Honda ST1100 1996+ Owner's Manual page 71

Installation
1. Reassemble removed parts in the reverse order of removal. NOTE:
When installing the wheel, position the speedometer gearbox so that the lug on
o
the gearbox is against the rear of the stopper lug on the left fork.
To install the sensor:
Turn the front wheel so one of the poles of the pulser ring and sensor face each
o
other.
Insert a feeler gauge 0.5 mm furnished in the tool kit between the sensor and
o
pole, then hold the sensor lightly against the pole.
Tighten the sensor mounting bolt securely.
o
Specified torque: 12 Nm (1.2 kgf-m, 9 Ibf-ft)
Remove the feeler gauge,
o
Rotate the front wheel one full turn to make sure that the pulser ring does not
o
interfere with the sensor.
- Copyright for this owners manual only ©2011 LIFRASCHAL -
71