Table of Contents
Advertisement
Chapter 6 PCI Bus Ethernet Interface
6.1 Introduction
The board is equipped with a high performance 32-bit Ethernet chipset
which is fully compliant with 802.3u 100Base-T or 802.3z/ab 1000Base-
T. It is supported by major network operating systems. It is also both
100Base-T and 10Base-T compatible.
The Ethernet port provides a standard RJ-45 jack. The network boot fea-
ture can be utilized by incorporating the boot ROM image files for the
appropriate network operating system. The boot ROM BIOS files are
combined with system BIOS, which can be enabled/disabled in the BIOS
setup.
6.2 Installation of Ethernet driver
Before installing the Ethernet driver, note the procedures below. You
must know which operating system you are using in your board Series,
and then refer to the corresponding installation flow chart. Then just fol-
low the steps described in the flow chart to quickly complete the installa-
tion.
Note:
6.2.1 Installation for MS-DOS and Windows 3.1
If you want to set up your Ethernet connection under the MS-DOS or
Windows 3.1 environment, you should first check your server system
model. For example, MS-NT, IBM-LAN server, and so on.
Then choose the correct driver to install in your biscuit PC.
The installation procedures for various servers can be found on the sup-
plied CD-ROM, the correct path being:
6.2.2 Installation for Windows 98/Me
PCI-6881 User Manual
The windows illustrations in this chapter are
examples only. Follow the steps and pay atten-
tion to the instructions which appear on your
screen.
D:\LAN\82551ER\W9xW2k
56
Advertisement
Table of Contents
