Chapter 6 PCI Bus Ethernet Interface
6.1 Introduction
The PCM-3341 is equipped with a high performance 32-bit Ethernet
chipset which is fully compliant with IEEE 802.3u 100 Mbps CSMA/CD
standards. It is supported by major network operating systems. It is also
both 100Base-T and 10Base-T compatible. The medium type can be con-
figured via the RSET8139.exe program included on the utility disk.
The Ethernet port provides a 10-pin 2 mm connector on board.
6.2 Installation of Ethernet driver
Before installing the Ethernet driver, note the procedures below. You
must know which operating system you are using in your PCM-3341, and
then refer to the corresponding installation flow chart. Then just follow
the steps described in the flow chart. You will quickly and successfully
complete the installation, even if you are not familiar with instructions for
Windows.
Note:
6.2.1 Installation for Windows 95/98/NT
1.
a. Insert the utility disc into the CD-ROM drive.
b. Folders:
U:\CD_CAT3\LAN\3341\Vga\Win95&98
c.Select on "Setup".
PCM-3341 User's Manual
The windows illustrations in this chapter are
examples only. You must follow the flow chart
instructions and pay attention to the instructions
which then appear on your screen.
48