Table of Contents
Advertisement
Refer to Figures 2 - 5.
CAUTION: Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
WARNING
Do not operate machine until completely assembled.
Do not operate machine until you have completely read
and understood this manual.
MOUNT SANDER
Refer to Figure 2.
• The sander must be installed in a well-lighted area with
correct power supply.
• Sander can be installed on either a workbench or a tool
stand by using bolts, lock washers, and hex nuts.
• The sander must be bolted to a firm and level surface.
• There must be enough clearance for the moving
workpiece during operation. There must be enough
room for safey operation of the machine.
• Figure 2 shows the base dimensions and mounting
holes.
Figure 2- Assembling Fence and Fence Bracket
22½"
13¾"
" Diameter
/
5
16
ATTACH ABRASIVE SLEEVES
Refer to Figures 3 and 4.
TO ATTACH ½ ABRASIVE SLEEVE
• Place the ½ table insert over spindle and onto the table.
The top side of the insert has directional arrows, as
shown.
• Slide sleeve over the spindle.
• Tighten the knob by turning counterclockwise to secure
sleeve in positon so that sleeve will not spin loose
during operation.
Figure 3- Attaching the 1/2" Sleeve
TO ATTACH ¾" – 3" ABRASIVE SLEEVES
Example: 2"
• Place the 2" table insert over spindle and onto the table.
The top side of the insert has directional arrows, as
shown.
• Slide 2" sleeve over the 2" drum first, then slide drum
with sleeve onto spindle.
• Place 2" drum washer on drum.
• Tighten the knob to secure drum in position. Knob and
washer must hold the drum securely so that it does not
spin loose during operation.
Figure 4- Attaching 2" Drum with Sleeve
11"
16½"
ONBOARD STORAGE
Onboard storage is provided to hold drums, inserts and
washers.
Figure 5- Onboard Storage
Drums with
Sleeves
Knob
Sleeve
Direction Arrow
on Insert
Knob
2" Drum
Washer
Direction Arrow
on Insert
Table Inserts
Drum Washers
3
Advertisement
Table of Contents
