Table of Contents
Advertisement
BACKSTOP
Refer to Figure 8
The backstop is a surface to sand against.
The backstop can be removed for polishing and contour
sanding.
• Remove screws and washers securing backstop. Place
screws, washers and backstop in a safe place for future
use.
Figure 8
4
DUST PORT OPTIONS
The dust ports can be easily connected to a dust
collection system with a large diameter shop vacuum
hose.
Sanding operations are inherently dusty. This sander is
equipped with a 1-3/4" OD belt dust port to help minimize
the amount of dust escaping into the surrounding air.
Attach the dust collection system vaccum hose to the
dust chute. NOTE: The use of a dust collection system is
strongly recommended when using the belt sander. Use
of a mask or respirator is still recommended even when
using a dust collection system.
MOUNTING THE SANDER TO WORK
SURFACE
Refer to Figure 9
CAUTION
Properly mount the sander to a workbench or stand if
during operation the sander has the tendency to tip over,
slide or walk on the work surface.
• Remove the four rubber feet from the sander.
• Position the sander in place on the work surface. Mark
the work surface using the holes in the sander base as
a template. Remove the sander from the work surface.
• Drill holes in the work surface at the marks.
• Secure the sander to the work surface using long bolts,
flat washers and hex nuts (not supplied) as shown.
NOTE: Bolts should be inserted from the top of the
sander and secured underneath the work surface with
flat washers, lock washers and hex nuts. A rubber
washer should be placed between the sander and the
workbench.
Screws and
Backstop
Washers
Figure 9
Bolt
Flat Washer
Rubber
Washer
Workbench
POWER SOURCE
WARNING
Do not connect to the power source until the machine is
completely assembled.
The machine is wired for 120 volts, 60 HZ alternating
current. Before connecting the machine to the power
source, make sure the switch is in the "OFF" position.
Running the unit on voltages which are not within range
may cause overheating and motor burn-out. Heavy loads
require that voltage at motor terminals be no less than the
voltage specified on nameplate.
GROUNDING INSTRUCTIONS
WARNING
Improper connection of equipment grounding conductor
can result in the risk of electrical shock.
• The machine should be grounded while in use to protect
operator from electrical shock.
• In the event of an electrical short circuit, grounding
reduces the risk of electrical shock by providing an
escape wire for the electric current.
• This machine is equipped with an approved 3-conductor
cord rated at 125V and a 3-prong grounding type plug
for your protection against shock hazards.
• Grounding plug should be plugged directly into a
properly installed and grounded 3-prong grounding-type
receptacle, as shown (Figure 10).
• The plug must be plugged into an outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
• Check with a qualified electrician or service personnel if
these instructions are not completely understood or if in
doubt as to whether the tool is properly grounded.
• Do not modify plug provided. If it will not fit in outlet,
have proper outlet installed by a qualified electrician.
Use only 3-wire extension cords, that have 3-prong
grounding type plugs and matching 3-conductor
receptacles that accept the machine's plug, as shown in
Figure 10.
Sander
Flat Washer
Hex Nut
Advertisement
Table of Contents
