Assembly; Mount The Work Table; Mount The Work Support - PowerTec BD4600 Owner's Manual

2
UNPACKING
Refer to Figure 1.
Check for shipping damage. Check immediately whether
all parts and accessories are included.
The sander comes assembled as one unit. Additional
parts which need to be fastened to sander, should be
2
located and accounted for before assembling.
ITEM DESCRIPTION
A Socket Head Screws
B Washer
C Work Support
D Hex Wrench 6 mm
E Adjustment Knob and Washer
F Work Table
G Miter Gauge
Figure 1
A B
D
F
WARNING
Do not use the machine until it is completely assembled
and you have read and understood the entire operating
manuals.

ASSEMBLY

TOOLS NEEDED
The following tools (not included) are needed to assemble
and adjust the belt/disc sander:
• 10 mm wrench
• 6 mm hex wrench (supplied)
• Combination square
• Phillips screwdriver

MOUNT THE WORK TABLE

Refer to Figure 2
• Position the work table horizontal to the sanding disc
QUANTITY
2
2
1
• Maximum distance between the work table and sanding
1
1
1
1
C
To prevent trapping the workpiece or fingers between
the table and the sanding disc adjust the work table to a
maximum of 1/16" from the sanding disc
Figure 2
E
G
Adjustment Knob

MOUNT THE WORK SUPPORT

Refer to Figure 3
• Secure the work support to the sanding belt support with
• The work support height must be adjusted to avoid
and insert the index pins into the work table pivot holes
in frame. Secure in place with adjustment knob and
washer as shown.
disc should be 1/16". To adjust, loosen the three bolts
securing the work table to the work table support. Adjust
the work table in or out to the 1/16". Tighten three bolts
securely.
NOTE: Work table will need to be adjusted each time
the work table is tilted.
WARNING
Holes in
Frame
Work Table
Index Pin
Washer
Work Table
Support
the hex screws and washers supplied.
contact with the sanding belt. Adjust work support and
tightening hex screws.
1/16" Maximum
Sanding Disc
Work Table