8
WARNING
Disconnect the unit from power source before servicing or
disassembling any components.
CLEANING
Keep machine and workplace clean. Avoid accumulation
of sawdust on the tool.
Be certain motor is kept clean and free of dust.
Use soap and water to clean painted parts, rubber parts
and plastic guards.
LUBRICATION
The shielded ball bearings in this unit are permanently
lubricated at the factory. They require no more lubrication.
• A light coat of paste wax on the work table, will make it
easier to feed the workpiece and prevent rust.
• Periodically apply grease to the worm gear (Ref.
No. 55).
MAINTENANCE
KEEP TOOL IN REPAIR
• If power cord is worn, cut, or damaged in any way, do
not operate the machine.
• Replace any worn, damaged, or missing parts. Use
parts list to order parts.
Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician.
NOTE