Table of Contents
Advertisement
WARNING
Any attempt to repair or replace electrical parts on this
tool may be hazardous. Repairs not listed here should be
performed by a qualified service technician.
WARNING
To prevent serious injury from tool failure, do not use
damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
WARNING
If the supply cord of this power tool is damaged, have it
replaced by a qualified service technician.
WARNING
Always turn the tool OFF and remove the plug from the
power source outlet before making any adjustments or
removing or installing accessories.
DUST COLLECTION BOX
Refer to Figure 7
To empty dust collection box
• Turn dust extraction box counter clockwise to unlock
and slide away from dust port.
• Empty contents of box into a trash receptacle, tap the
box to loosen debris.
To clean dust collection box filter
• Turn dust extraction box counter clockwise to unlock
and slide away from dust port.
• Press release tab to open dust collection box.
SYMPTOM
POSSIBLE CAUSE(S)
Motor does not run 1.
Machine not plugged in
2.
Blown fuse or tripped circuit breaker
3.
Internal damage or wear
Excessive noise
1.
Internal damage or wear
Not sanding
1.
Sandpaper problem
effectively
2.
Using incorrect grit
3.
Dust collection box full
4.
Dust collection box filter is dirty
MAINTENANCE
• Remove the filter.
• To clean filter tap it on the side of a trash receptacle or
blow it with compressed air.
Figure 7
• Replace filter into collection box.
LUBRICATION
Your tool has been properly lubricated and is ready to use.
It is recommended that tools with gears be re-lubricated
with a special gear lubricant at every brush change.
CLEANING
After each use, wipe external surfaces of the tool with a
clean cloth.
WARNING
Certain cleaning agents and solvents damage plastic
parts. Some of these are: gasoline, carbon tetrachloride,
chlorinated cleaning solvents, ammonia and household
detergents that contain ammonia.
TROUBLESHOOTING
CORRECTIVE ACTION
1.
Plug power cord into electrical receptacle
2.
Replace fuse or reset the circuit breaker
3.
See a service technician
1.
See a service technician
2.
Using incorrect grit
2.
Check sandpaper grit for job being performed. Coarse
sandpaper (36-80 grit) Fine sandpaper (100-600 grit)
3.
Empty dust collection box
4.
Clean dust collection box filter
Release Tab
5
5
Filter
5
5
5
Advertisement
Table of Contents
