Table of Contents
Advertisement
About This Guide
Document Purpose and Intended Audience
Document Summary
7900-A2-GB20-00
This guide contains information needed to install, configure, and operate the
Hotwire Model 7900 Basic Maintenance Processor (also known as an MTU-M
nest card) for nest-mounted Hotwire 7900 termination units.
It is expected that readers of this document are central office/site (CO) or special
service installation technicians or network engineers who have an understanding
of digital subscriber line systems and High-bit-rate Digital Subscriber Loop
(HDSL) and Symmetric Digital Subscriber Loop (SDSL) transmission systems
plus the deployment of such systems in a telephone company or private network
environment.
Section
Description
Chapter 1
About the Hotwire Model 7900 Basic Maintenance
Processor . Describes the features of the Model
7900-F1-500 and typical configurations.
MTU-M Installation Procedures . Describes how to install the
Chapter 2
MTU-M in the Hotwire Model 7900 Nest and connect
multiple adjacent nests.
Initial Setup Instructions . Provides initial setup instructions
Chapter 3
for the MTU-M, including initial IP addressing and system
operational settings.
System Terminal Interface. Provides procedures for
Chapter 4
connecting a VT100-compatible system terminal to the
MTU-M front panel or nest rear panel. This chapter also
provides procedures to access MTU-M functions through a
modem.
Chapter 5
MTU-M Status and Performance Functions. Describes how
to monitor the status and performance of nest card
termination units.
March 1998
v
Advertisement
Table of Contents
