Record A Par Can Chase - Elation DMX Operator Pro User Manual

7.6.1 Record a Par Can Scene (Cont.)
(4) Adjust the "MASTER" fader all the way up to ten (10). The LCD will display the
following:
(5) Next, use the eight (8) faders, labeled 129-136, to set your desired Par Can scene.
(6) Once your look is set, press the "RECORD" button to SAVE. All LED's will flash once
confirming that your scene has been saved. Your LCD will once again display the
following:
(7) To record additional Scenes, please repeat steps 3 thru 6.
(8) To exit record mode, press the "ESC" button one time.

7.6.2 Record a Par Can Chase

(1) Press and hold down the "RECORD" button for three (3) seconds or until the green
LED next to the RECORD button comes on. The LCD will display the following:
(2) Select the "CHASE" button 1-6, where you wish to record to. The selected Chase
LED will flash repeatedly. For example, if you select CHASE #1, the LED above the
#1 CHASE button will flash repeatedly and your LCD will display the following:
MSTR255
SAVE ESC PAGE01
SELECT A SCENE
OR CHASE! PAGE01
SELECT A SCENE
OR CHASE! PAGE01
EDIT CHASE1/TL00
ADD ESC STEP00
DMX OPERATOR PRO
24