Palm PRE 2 User Manual page 222

8 Remove the battery by pulling the tab that appears at the top of the
battery.
9 Insert the new battery.
10 Position the back cover over the phone and gently press the two clasps
(a), located at the top corners. Then press the two clasps (b) halfway
down either side of the phone.
222 Chapter 14 : Troubleshooting
11 Slide out the keyboard (see Slide out the
two clasps (c) at the bottom corners.
12 Press and hold the power
phone until you see a logo on the screen (approximately five seconds).
Then wait until your phone completes setup.
If your phone does not turn on after you insert the battery and press and hold
TIP
power, you may need to charge the battery (see
keyboard), and then press the
button on the upper-right corner of your
Charge the battery).