Hawking HI-GAIN HAW2R1 User Manual page 96

Local Port
Range (4):
Remote IP
Address: (5):
Remote Port
Range (6):
Traffic Type (7):
Protocol (8):
After you finish with all settings, click "Save" (9). You will be brought back to
previous menu, and the rule you just set will appear in current QoS table; if you did
anything wrong, you'll get an error message when you click "Save", correct your input
by the instructions given by the error message.
Please input the range of local (source)
port number that will be affected by this rule. If you want to
apply this rule on port 80 to 90, please input "80-90"; if you
want to apply this rule on a single port, just input the port
number, like "80".
Specify the remote (destination) IP address
that will be affected by this rule. Please input the starting IP
address in the left field, and input the end IP address in the right
field to define a range of IP addresses, or just input the IP
address in the left field to define a single IP address.
Please input the range of remote (destination)
port number that will be affected by this rule. If you want to
apply this rule on port 80 to 90, please input "80-90"; if you
want to apply this rule on a single port, just input the port
number, like "80". If the remote (destination) IP address and /or
port number is universal, just leave it blank.
Please select the traffic type of this rule, available options are
None, SMTP, HTTP, POP3, and FTP. You can select a specific
traffic type for this rule, if you want to make this rule as a IP
address based rule (apply the limitation on all traffics from / to
the specified IP address / port number), select "None".
Please select the protocol type of this rule,
available options are TCP and UDP. If you don't know what
protocol your application uses, please try 'TCP' first, and switch
to "UDP" if this rule doesn't seems to work.
90