Sd Memory Video; Switching The Sd Memory Video Screen; Auxiliary Device (Optional); Operating Auxiliary Devices (Optional) - Alpine INA-W910R Owner's Manual

SD Memory Video

Switching the SD Memory Video Screen

Video data recorded in the SD memory card can be played back by the
player built in this unit.
WARNING
It is dangerous for the driver to watch the TV/Video
while driving the vehicle. The driver may be distracted
from looking ahead and an accident could occur.
Install the INA-W910R correctly so that the driver
cannot watch TV/Video unless the vehicle is stopped
and the emergency brake is applied.
If the INA-W910R is not installed correctly, the driver
will be able to watch the TV/Video while driving the
vehicle and may be distracted from looking ahead and
cause an accident. The driver or other people could
be severely injured.
• If you try to activate the auxiliary device while driving, the display
will show the warning-Picture off for your safety.
1
Press SOURCE/ on the unit.
The Source Select screen is displayed.
2
Touch [SD card].
The playback starts.
• For Memory video operation, refer to the Owner's Manual of "SD
Video Player Owner's Manual" stored in the supplied CD-ROM.
• The SD-Video picture cannot be displayed on Rear monitor via AUX
OUT port.
• The SD-Video source can only output Mono sound.
70
-EN
Auxiliary Device
(Optional)

Operating Auxiliary Devices (Optional)

To operate your devices connected to the AUX terminals on the rear
panel of INA-W910R (AUX1 mode) or to the iPod (V)/AUX Input
connector by using an AV/RCA interface cable (sold separately) (AUX2
mode), follow the procedure described below.
WARNING
It is dangerous for the driver to watch the TV/Video
while driving the vehicle. The driver may be distracted
from looking ahead and an accident could occur.
Install the INA-W910R correctly so that the driver
cannot watch TV/Video unless the vehicle is stopped
and the emergency brake is applied.
If the INA-W910R is not installed correctly, the driver
will be able to watch the TV/Video while driving the
vehicle and may be distracted from looking ahead and
cause an accident. The driver or other people could
be severely injured.
• If you try to activate the auxiliary device while driving, the display
will show the warning-Picture off for your safety.
1
Press SOURCE/ on the unit.
The Source Select screen is displayed.
2
Touch [Aux1]* or [Aux2].
The external input screen is displayed.
3
Touch [NTSC/PAL] to change the video input.
* The name which is given as the source name in "Setting the AUX
Mode" on page 48 is displayed.
• If the AUX mode is not displayed on the main menu, set AUX1 IN to
ON or AUX2 IN to AUX by following "Setting the AUX Mode"
(page 48).
• The setting of switching NTSC/PAL, which you have set in this
section, can be used in same way in "Switching the Visual Input
Signal System" on page 49.
• The display mode changes by touching [WIDE].
For operation, refer to "Switching Display Modes" on page 37.