Table of Contents
Advertisement
2.3
Detailed Installation
This section provides detailed instructions for installing a MegaRAID 320
Storage Adapter.
Step 1. Unpack the Storage Adapter
Unpack and remove the Storage Adapter. Inspect it for
damage. If it appears damaged, or if any items listed below are
missing, contact your LSI support representative. The
MegaRAID 320 Storage Adapter is shipped with
–
the MegaRAID Universal Software Suite CD, which
contains MegaRAID drivers for supported operating
systems, an electronic version of this User's Guide, and
other related documentation
–
a license agreement
Step 2. Power Down the System
Turn off the computer and remove the AC power cord. Remove
the system's cover. Refer to the system documentation
for instructions.
Step 3. Check the jumpers.
Ensure that the jumper settings on the your Storage Adapter
are correct. Refer to
Adapter Characteristics"
with their jumpers and connectors.
Step 4. Install the MegaRAID 320 Storage Adapter
Select a PCI, PCI-X, or PCI-Express slot, and align the Storage
Adapter PCI bus connector to the slot. Press down gently but
firmly to ensure that the card is properly seated in the slot, as
shown in
Figure
PCI-Express controller. Then screw the bracket into the
computer chassis.
Detailed Installation
Copyright © 2003-2008 by LSI Corporation. All rights reserved.
Chapter 3, "MegaRAID 320 Storage
for diagrams of the Storage Adapters
2.1.
Figure 2.2
shows installation of the
2-3
Advertisement
Table of Contents
