Table of Contents
Advertisement
2-12
Step 2. Plug the 68-pin connector on the other end of the internal SCSI
ribbon cable into the SCSI connector on the internal SCSI
device, as shown in
Figure 2.10 Connecting Multiple Internal SCSI Devices
Step 3. If you have another internal SCSI device, connect the internal
SCSI ribbon cable to it.
can connect other devices if the cable has more connectors.
The Ultra320 SCSI host adapters support up to 15 SCSI
devices connected to each SCSI channel.
Step 4. Be sure that termination is enabled at the end of the cable that
is farthest from the SCSI host adapter. Refer to
"Detailed Installation," page
bus termination.
Hardware Installation
Copyright © 2003-2008 by LSI Corporation. All rights reserved.
Figure
2.10.
Figure 2.10
shows how to do this. You
2-3, for details on SCSI
Section 2.3,
Advertisement
Table of Contents
