Detailed Installation Instructions - LSI MegaRAID SATA 150 User Manual

2.4

Detailed Installation Instructions

Here are detailed installation instructions for installing the SATA150
storage adapter.
Step 1. Unpack the SATA150 storage adapter and inspect it for
damage.
Unpack and install the storage adapter in a static-free
environment. Remove it from the anti-static bag and inspect it
for damage. Contact LSI Logic or your MegaRAID OEM
support representative if the storage adapter appears
damaged.
Step 2. Power down the system and remove the cover.
Turn off the computer and physically remove the power cord
from the back of the power supply. Remove the cover from the
computer chassis.
Step 3. Configure the jumpers on the SATA150-6 or SATA150-4 storage
adapter.
Chapter 3, "SATA150 Storage Adapter Characteristics"
jumper definitions and locations. The SATA150-2 does not have
any jumpers.
Step 4. Insert the MegaRAID SATA150 storage adapter in a PCI slot.
Be sure you are properly grounded, so you do not damage the
adapter with static electricity. Press down gently but firmly to
properly seat the storage adapter in the slot, as shown in
Figure 2.1.
Detailed Installation Instructions
Copyright © 2002–2004 by LSI Logic Corporation. All rights reserved.
lists
2-3