Lindy 39390 User Manual page 41

English Manual
STEP 5 (connecting the remote receiver)
Power down your computer. Power down the remote receiver. Disconnect the twisted pair cable from the remote
receiver. Do not power any of the devices yet. Connect the remote receiver to your computer as shown below.
To do this you will need a keyboard cable (6 pin mini-DIN male to 6-pin min-DIN male, all lines connected). If you
have a KVM switch product the chances are that you will have one of these connecting the switch to a computer.
You only need to connect the keyboard cable between the remote receiver and the computer. Plug the monitor
directly into the back of the computer.
This configuration might seem strange to you because the keyboard port on the C5 KVM remote receiver would
normally be connected to a keyboard and not to a computer keyboard port. The product is designed to reverse the
operation of the keyboard port during the flash upgrade process.
STEP 6 (upgrading the remote receiver)
Set the C5 KVM's option switch 1 to the ON position. Power the C5 KVM remote receiver by connecting the power
adaptor. Insert the DOS disk into your computer's floppy drive and power on your computer. The upgrade should
be performed automatically. When the upgrade has completed, switch off your computer and disconnect the
remote receiver. Set option switch 1 back to the OFF position.
Reconnect the upgraded C5 KVM as shown in figure 6.
41
LINDY KVM Extender C5-Series Installation and Use page