Lindy 39390 User Manual page 17

English Manual
REMOTE unit – Switch 4
This switch is used to select the required video compensation mode. When the switch is in the OFF position,
automatic video compensation is selected. In automatic compensation mode, the C5 KVM will check the length of
twisted pair cable linking the local and remote units when it is powered on. It will then adjust the video
compensation amplifiers. In manual compensation mode, the video compensation setting may be adjusted by the
user.
LOCAL unit – Switch 1
Set this switch to the OFF position for normal operation. This switch is used to set the C5 KVM local unit into
upgrade mode so that new firmware can be downloaded into its flash program memory.
LOCAL unit – Switch 2
This switch sets "transparent mode" operation. This mode is useful if the C5 KVM is to be used to linked to a KVM
switch. Cascaded KVM switches often use undocumented data to signal special conditions. In transparent mode
the C5 KVM will enable this undocumented data to be transferred between devices.
LOCAL unit – Switch 3
If this switch is set to the ON position then the remote unit will go directly into compensation / configuration mode
at power on. This enables a password locked remote unit to be reset. See section 4.6 for further details
LOCAL unit – Switch 4
This switch may be used to reset the local unit without disconnecting the power. In the OFF position the C5 KVM
will operate normally. In the ON position the C5 KVM will suspend all operation and reset itself to the power off
condition. Cycling the switch from the OFF position to the ON position and back to the OFF position again will
perform a reset without having to disconnect the computer connection cable.
17
LINDY KVM Extender C5-Series Installation and Use page