Table of Contents
Advertisement
8
9
Important: The belt loop
must be led into this hook
Remove the plastic
caps (9) from the ISOfix
connectors (7) by pressing
down the ISOfix release
7
Use the ratchet (6) to adjust
6
the front brace to the inmost
position. The ratchet (6)
is used to adjust the front
6
brace in both directions.
Switch the knobs on the
ratchet to change direction.
Assemble the floor support
before you install the iZi Kid
ISOfix in your car.
12
The floor support (12) must
go through the belt loop
(14). The belt loop must
also be led into the hook
on the floor support.
Do not fasten the locking
bolt (13) yet.
7
Advertisement
Table of Contents
