Tools And Materials Required For Installation; Assembly Instructions - Vogelzang International Sentry Coal VG810CL Owner's Manual

Coal stove

Hide thumbs Also See for Sentry Coal VG810CL:

Owner's manual (19 pages)

Owner's manual (19 pages)

Table Of Contents

Table of Contents

ASSEMBLY INSTRUCTIONS

tools

Pencil

6 ft / 2m Folding Rule or Tape Measure

Tin Snips

Drill: Hand or Electric

1/8˝/3mm dia. Drill Bit (sheet metal screws)

1/4˝/6mm dia. Drill Bit (damper installation)

Screwdriver (blade & Phillips types)

6mm Nut Driver or Ratchet with 6mm Socket

Safety Glasses

Gloves

1. Uncrate the stove and remove cardboard packing

and protective poly bag. (Save cardboard for further

assembly.)

2. Remove legs, heat shield, damper, and hardware

pack from inside firebox.

3. Place flattened carton behind stove and carefully

turn stove onto its back.

4. Place both legs upside down and attach the heat

shield assembly (from step 4) between the legs.

Align the holes in the heat shield assembly with

those in the mounting flange of the leg assemblies

and secure with four (4) self-tapping screws.

5. Attach leg/heat shield assembly to the base of the

stove using eight (8) self-tapping screws (fig. 1).

6. Carefully lift stove to upright position.

7. Locate the door knob and machine screw in the

hardware pack. Open the cabinet door by reaching

under the cabinet frame and pulling the door open.

8. Install the door knob onto the outside of the door.

Install the machine screw through the latch bracket,

door, and into the knob. Tighten securely (fig. 2).

WARNING: METAL HEAT SHIELD PANELS

FASTENEDBETWEEN LEGS ACT AS HEAT

DEFLECTORS. THESE PANELS MUST BE IN

PLACE FOR SAFE OPERATION.

VGZ-011 / 20120105.0