Tools And Materials Required For Installation; Assembly Instructions - Vogelzang International Sentry Coal VG810CL Owner's Manual

ASSEMBLY INSTRUCTIONS

NOTICE: Vogelzang International Corp. grants no warranty, stated or implied, for the installation or maintenance
of your wood stove and assumes no responsibility of any incidental or consequential damages.

TOOLS AND MATERIALS REQUIRED FOR INSTALLATION

TOOLS
Pencil
6 foot Folding Rule or Tape Measure
Tin Snips
Drill: Hand or Electric
1/8" dia. Drill Bit (sheet metal screws)
1/4" dia. Drill Bit (damper installation)
Screwdrivers (phillips and blade type)
6mm Nut Driver or Ratchet with 6mm Socket
Safety Glasses
Gloves
1. Uncrate the stove and remove cardboard pack-
ing and protective poly bag. (Save cardboard
for further assembly.)
2. Remove legs, upper and lower heat shields,
damper, and hardware pack from inside fire-
box.
3. Place flattened carton behind stove and care-
fully turn stove onto its back.
4. Join the upper and lower heat shields with four
(4) self-tapping screws (fig. 1).
Fig.1 Leg
& Heat Shield
Assembly
Lower Heat Shield
WARNING: METAL PANELS FASTENED BE-
TWEEN LEGS ACT AS HEAT DEFLECTORS.
THESE PANELS MUST BE IN PLACE FOR SAFE
OPERATION.
5. Place both legs upside down and attach the heat
shield assembly (from step 4) between the legs.
Align the holes in the heat shield assembly with
those in the mounting flange of the leg assem-
blies and secure with four (4) self-tapping
screws.
6. Attach leg/heat shield assembly to the base of
the stove using self-tapping screws provided
(fig. 1).
7. Carefully lift stove to upright position.
8. Locate the door knob and machine screw in
the hardware pack. Open the cabinet door by
VGZ-011 / 090705.0
Upper Heat Shield
Leg
Assembly
MATERIALS
(NOTE: The following items are NOT included with your stove)
Chimney Connection: 6" black steel (24 ga. min.) straight stove
pipe or elbow (as required)
1/2" Sheet Metal Screws
Chimney: Existing 6" Lined Masonry Chimney or 6" Inside Dia.
listed Type HT chimney.
Flooring Protection: 42" x 60" as specified (see figures 3–5)
Furnace Cement (manufacturer recommends Rutland Code 78
or equivalent)
reaching under the cabinet frame
and pulling the door open.
9. Install the door knob onto the outside
of the door. Install the machine
screw through the latch bracket,
door, and into the knob.
Tighten securely.
(fig. 2).
Fig. 2 Cabinet
Door Knob Assembly
VG810CL SENTRY COAL™ /
Page 3