Vogelzang International Sentry Coal VG810CL Owner's Manual

Vogelzang International Sentry Coal VG810CL Owner's Manual

Hide thumbs Also See for Sentry Coal VG810CL:

Advertisement

Quick Links

S
entry
model VG810CL
READ ALL INSTRUCTIONS CAREFULLY
BEFORE STARTING THE INSTALLATION
OR OPERATING THE STOVE. FAILURE TO
FOLLOw INSTRUCTIONS mAY RESULT
IN PROPERTY DAmAGE, BODILY INjURY,
OR EVEN DEATH.

SAFETY INSTRUCTIONS

SAFETY NOTICE: IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE/BUILDING FIRE mAY
RESULT. FOR YOUR SAFETY, CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT PERmITS,
RESTRICTIONS, AND INSTALLATION REqUIREmENTS FOR YOUR AREA.
READ ALL INSTRUCTIONS CAREFULLY.
1. The installation of this stove must comply
with your local building code rulings. Please
observe the clearances to combustibles (see
reference figures 3–5). Do not place furni-
ture or other objects within the clearance
area.
2. Verify that the stove is properly installed
before firing the stove for the first time.
After reading these instructions, if you have
any doubt about your ability to complete
your installation properly, you must ob-
tain the services of a professional licensed
installer familiar with all aspects of safe
and correct installation. DO NOT use
temporary or makeshift compromises
during installation.
3. DO NOT store coal, kindling, flammable
liquids or other combustible materials too
close to the unit. Refer to certification label
on back of unit and reference figures 3 – 5
in this manual.
VGZ-011 / 20110513.1
C
oal
(save this manual for future reference)
S

Owners manual

Do NOT use this stove in a
mobile home, manufactureD home,
trailer or tent – NO EXCEPTIONS!
This stove meets
U.S. Test Standard:
UL 1482-1996
4. Do not install this stove in a mobile home,
manufactured home, trailer or tent
(NO EXCEPTIONS! per HUD Federal
Standard: 24 CFR Ch.XX).
5. If any parts are missing or defective, please
notify the dealer or manufacturer immediately.
DO NOT OPERATE A STOVE THAT IS
MISSING ANY PARTS!.
6. Do not tamper with combustion air control
beyond normal adjustment capacities.
7. Always connect this stove to a chimney and
vent to the outside. Never vent to another room
or inside a building. DO NOT CONNECT
THIS UNIT TO A CHIMNEY FLUE SERV-
ING ANOTHER APPLIANCE.
8. DO NOT CONNECT a coal burning stove
to an aluminum Type B gas vent. This is not
safe. Use approved masonry or a UL 103 HT
(U.S) Listed Residential Type and Building
Heating Appliance Chimney. Use a 6" diam-
eter chimney or larger, that is high enough to
give a good draft. (See specifics in installation
instructions).
Vogelzang International Corporation
400 West 17th Street
Holland, Michigan 49423
www.vogelzang.com
Phone: 1-616-396-1911
Fax: 1-616-396-1971
VG810CL Sentry CoaL™ /
tove
continued on next page
Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sentry Coal VG810CL and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Vogelzang International Sentry Coal VG810CL

  • Page 1: Owners Manual

    (See specifics in installation instructions). continued on next page Vogelzang International Corporation 400 West 17th Street Holland, Michigan 49423 www.vogelzang.com Phone: 1-616-396-1911 Fax: 1-616-396-1971 Page 1 VGZ-011 / 20110513.1 VG810CL Sentry CoaL™ /...
  • Page 2 When installing your stove, use care in handling. Clean with soap and warm water when stove is NOT hot. Do not use any acids or scouring soap, as these wear and dull the finish. Page 2 / VG810CL Sentry CoaL™ VGZ-011 / 20110513.1...
  • Page 3: Tools And Materials Required For Installation

    ASSEmblY INSTRUCTIONS NOTICE: Vogelzang International Corp. grants no warranty, stated or implied, for the installation or maintenance of your wood stove and assumes no responsibility of any incidental or consequential damages. TOOLS AND mATERIALS REqUIRED FOR INSTALLATION tools materials (NOTE: The following items are NOT included with your stove)
  • Page 4: Locating Stove

    DASHED LINE SHOWS STRAIGHT OUT CHIMNEY CONNECTOR 15" AND ADDITIONAL FLOOR PROTECTOR REQUIRED 42" 19" SIDEWALL 8" FLOOR PROTECTOR 8" 14" 32" 16" Fig. 3 – TOp VIEw Minimum Clearance Dimensions from Combustible Surfaces Page 4 / VG810CL Sentry CoaL™ VGZ-011 / 20110513.1...
  • Page 5: Floor Protector

    NOTE: This damper is necessary for the proper operation of the stove and to meet EPA emissions requirements for heating appliances. It muST be installed before use.(NO EXCEPTIONS) Fig. 6 – Draft Damper Installation Page 5 VGZ-011 / 20110513.1 VG810CL Sentry CoaL™ /...
  • Page 6: Connector Pipe Installation

    “LOCATING STOVE” PAGE 3 FOR ADDITIONAL 90° bends be used in the stovepipe installa- SPECIFICATIONS. tion. The use of more than two 90° bends may CORRECT wRONG wRONG Fig. 7 – Stovepipe/Flue Connections Page 6 / VG810CL Sentry CoaL™ VGZ-011 / 20110513.1...
  • Page 7: Chimney Connections

    4. Never use a chimney to ventilate a cellar or basement. 5. Contact your local building authority for approved methods of installation and any necessary permits and/or inspections. Fig. 9 - Chimney Construction Through Attic Space Page 7 VGZ-011 / 20110513.1 VG810CL Sentry CoaL™ /...
  • Page 8 Before conversion, make sure the existing chimney Fig. 11 - Chimney Connection to Firebox is structurally sound, the chimney incorporates a Through Masonry wall Continued on next page Page 8 / VG810CL Sentry CoaL™ VGZ-011 / 20110513.1...
  • Page 9: Fireplace Installation

    The stove warranty will be void with such an installation. Do not create a hazard in your home by connecting in FIG. 12 - Fireplace Conversion this manner. Page 9 VGZ-011 / 20110513.1 VG810CL Sentry CoaL™ /...
  • Page 10: Operating Instructions

    REPLACE ImmEDIATELY IF STOVEPIPE for starting the fire. IS RUSTING OR LEAKING SmOKE INTO 3. Light fire, close and secure the feed door. THE ROOm. Continued on next page Page 10 / VG810CL Sentry CoaL™ VGZ-011 / 20110513.1...
  • Page 11: Adding Fuel

    (figure 13B). 3. To close, lift the top until the support rod is unlatched. Fig. 13 4. Pull the support rod forward as you lower Thermostat Adjustment Access the cabinet top. Page 11 VGZ-011 / 20110513.1 VG810CL Sentry CoaL™ /...
  • Page 12: Chimney Draft

    Draft wheel top being lower than another part of the house or a Adjustment nearby tree. The wind blowing over a house or tree, Continued on next page Page 12 / VG810CL Sentry CoaL™ VGZ-011 / 20110513.1...
  • Page 13: Chimney Maintenance

    Failure to remove creosote may result SPECTED BY A qUALIFIED PERSON BEFORE in ignition and may cause a house/building fire. USING AGAIN. Creosote may be removed using a chimney brush Page 13 VGZ-011 / 20110513.1 VG810CL Sentry CoaL™ /...
  • Page 14 Knob, thermostat ........1 Screw, 8-32x1/4” Mach......1 Latch, Spring ..........1 Support, Hinge .......... 1 nut, 10-24 ..........8 Clip, Hinge ..........1 Screw, 10-24x1/2” Flat Head..... 8 Page 14 / VG810CL Sentry CoaL™ VGZ-011 / 20110513.1...
  • Page 15 Cog, right Hand, Shaker Grate ....1 Cog, Left Hand, Shaker Grate ....1 nut, 1/4-20 ..........1 Door, ash ..........1 Grate, right Hand ........1 Steel Liner ..........1 Grate, Left Hand ........1 Page 15 VGZ-011 / 20110513.1 VG810CL Sentry CoaL™ /...
  • Page 16 Rbrick + Rmin.brd = 0.80 + 0.431 = 1.231 = Rsystem Step 4: Compare Rsystem to Rspecs Rsystem = 1.231 is larger than Rspecs of 0.893. System R-value exceeds the required specifications and therefore is an acceptable alternative. Page 16 / VG810CL Sentry CoaL™ VGZ-011 / 20110513.1...
  • Page 17 24 gauge thickness. Fasten- ers used to secure chimney section shall not penetrate chimney flue liner. Page 17 VGZ-011 / 20110513.1 VG810CL Sentry CoaL™ /...
  • Page 18 Attaches easily to existing panels on Vogelzang stove models VG820E and VG810CL. Switch/ther- mostat unit may be mounted in different positions for various comfort levels.

Table of Contents