Table of Contents
Advertisement
Altos R920 Installation Configuration Guide
4.
Follow the instruction to load the integrated SAS
hardware RAID driver from the driver diskette.
5.
At the package selection step, select Software
Development for the installation package.
6.
Please follow the normal procedure to finish the
installation.
Gigabit Ethernet Driver Installation
NOTE. Please install the
the CD #1 of Red Hat Enterprise Linux 5 EM64T prior to
install the Gigabit Ethernet driver.
NOTE. Please install the
with the CD #1 of Red Hat Enterprise Linux 5 EM64T prior to
install the Gigabit Ethernet driver in PAE mode kernel.
1.
You can find the Intel 82563EB driver in EasyBUILD 8.0
build 100. Please refer to directory of the 82563EB
driver in Driver Required section and copy the driver
from the EasyBUILD 8.0 build 100 to HDD first.
# mount /dev/dvd /mnt
# cp –R /mnt/Disk/R920/NIC/Intel/pro1000.lx/. /tmp
2.
Remove the OS built-in NIC driver
# rmmod e1000.ko
3.
Change the directory to the driver source and install the
driver
# cd /tmp/src/
# make install
# insmod e1000.ko
4.
Run the kudzu utility, it will auto detect the Intel
82563EB network controller and help you to configure it.
# kudzu
5.
Restart the network service to bring up both of the
network interfaces.
# service network restart
Gigabit Ethernet Driver Installation (I/O Expansion Module)
If the optional I/O Expansion module is installed on Altos
R920, there are two additional Intel 82575EB Gigabit Ethernet
available on Altos R920.
kernel-devel-<version>
kernel-PAE-devel-<version>
28
package with
package
Advertisement
Table of Contents
