Printing Using The Manual Feed - Oce 9400-II User Manual

Printing using the manual feed

There are two possibilities to select manual feed:
via remote control commands added to the print file (by means of Plot
Director, drivers (see 'Use of the Scan-to-File option' on page 75).
by changing the 'MEDIA MODE' in the program mode.
If the user wants to use manual feed, he has to:
program the media settings on the printer, refer to 'Programming media
1
settings' on page 48.
send the file.
2
wait until the message 'FEED SHEET' appears in the printer display.
3
feed the sheet of paper portrait into the printer.
4
hold the paper until the engine pulls-in the first part of the sheet.
5
If the user has selected manual feed in a print file, the printer will ask the user
via the operating panel, to feed the sheet into the printer, at the moment this job
is processed. There will be a user-selectable time-out between 30 and 300
seconds on feeding the sheet. Default timeout is 60 seconds. See 'Setting the
time-out for manual feed' on page 50. If the user does not feed the sheet within
this time the job is flushed and the next job will be processed.
Inserting print material in the manual feed
Feed the print material centrally into the feed table in accordance with the
1
guidelines (see figure 18).
The minimum length of the print material must be 420 mm.
Note:
[18] Manual feed
(Re)load media and toner 47