Table of Contents
Advertisement
Maintenance
Leveling Your Ironman Cycle Trainer
The Ironman Cycle Trainer can be leveled to compensate for uneven surfaces. To level the bike, raise or
lower the four leveling bolts located on the underside of the front and rear stabilizers by screwing them in or
out as needed.
Daily Maintenance
After every use of your Ironman Cycle Trainer, use a damp cloth to wipe your unit free from sweat.
Flywheel Maintenance
Over time your may need to adjust the tension of the chain on your Ironman Cycle Trainer. To do this:
1. Use an 19mm wrench to loosen the bolts on each side of the flywheel as shown in Figure 1.
2. Remove plastic plugs in the front frame tube as shown in Figure 2. Use an allen wrench to tighten the two
bolts inside the frame tube by turning them clockwise evenly until there is about 3/16" slack in the chain.
3. Use the adjustable wrench to tighten back the bolts in Figure 1.
Note: The steps above can also be performed to reduce the side to side motion or "wobble" of the flywheel.
Just adjust the allen bolts from Step 2 by turning them clockwise or counter-clockwise until the motion is with-
in a .186" tolerance (Per Side) .
Figure 2
Figure 1
11
Advertisement
Table of Contents
