Table of Contents
Advertisement
5
Basic Operations
correspondent selector knob, the channel number flashes in this
situation, the channel number will increase 10 channels by each gear of
selector knob. Press microphone [ UP/DOWN ] key also able to adjust
the channel.
If there is any empty channel, the adjustment will ignore it and jump to
next channel.
NOTE
INPUT CHANNEL THROUGH MICROPHONE NUMBER KEY
In channel mode, you can switch to desired channel by press 3 of the
microphone numeric key (001-758). For example input 001 get channel 1;
input 030 is channel 30; input 512 is channel 512. If the input channel is
not programmed with frequency, the transceiver will emit a warning beep
and return to last channel.
SWITCH BETWEEN MAIN BAND AND SUB BAND
This transceiver is default on dual receive,
a "MAIN" icon will displays in the top right of
12
the working frequency. The transmitting is only
on the Main band. When the left Band is Main
band, press the right selector knob will switch
the right Band to Main band. Then press the left selector knob will switch
the left Band to Main band.
SELECTING THE FREQUENCY BAND
1. Choose for Left band: press the left side
mode, press the left selector knob over 1 second then repeat the same
operation to switch the left band between 118-180 MHz (RX: 118-174
MHz, TX: 136-174 MHz), 220-260 MHz (RX only), 350-299 MHz (RX
only) or 400-490 MHz (*)
2. Choose for Right band: press the right side
mode, press the right selector knob over 1 second then repeat the
same operation to switch the right band between 136-174 MHz and
400-490 MHz (*).
able t o receive. When they receive any signal,
the BUSY icon and signal strength icon will appear in the correspondent
area of the LCD. And you can hear the calling
Off Momentary to monitor the weak signal.
1. Squelch Off: Hold
2. Squelch Off Momentary: Keep hold
key to switch it to VFO
microphone approximately 2.5-5.0 cm from your mouth, and then speak
into the microphone in your normal voice to get best timbre.
key to switch it to VFO
This transceiver can be set working on 2 UHF bands or 2 VHF bands.
NOTE
RECEIVING
In standby, both left and right bands are
If the transceiver has set at higher squelch level, it may fail to hear the
calling. If the Busy and signal strength icon display in left band or right
band, but can not hear the calling, means the signal is with matching
NOTE
carrier but dis-matching signaling.
SQUELCH OFF/SQUELCH OFF MOMENTARY
Long press of
key can be programmed as Squelch Off or Squelch
key until hear "Du" beep, the squelch is off,
repeat the above operation to resume squelch.
Release the key to resume squelch.
In standby, press the microphone
to turn on the squelch.
NOTE
TRANSMITTING
Hold PTT key, the transceiver change to transmitting. Please hold the
The transmitting only available on Main band, the TX icon will display in
the top right corner of the Main band frequen
NOTE
key to disable squelch,
to cancel squelch, press it again
Hide quick links:
Advertisement
Table of Contents
