Grizzly H2912 Instruction Manual page 9

Oiling The Nailer/Stapler
Special oil has been included with your
new Grizzly nailer/stapler to help maintain
its useful life. Place one drop of oil in the
nailer/stapler air inlet (as shown in Figure
5) before every use. Wipe off any excess
oil near the nailer/stapler exhaust to avoid
dust build-up. When the oil that was includ-
ed with the nailer/stapler has been com-
pletely used, replace with Grizzly Model
G2820 Pneumatic Tool Oil.
Another option to manual oiling would be
to install a lubricator in your air compressor
line. If your air compressor line already has
a lubricator, then regular lubrication of your
nailer/stapler will not be necessary. Just
make sure there is always oil in the lubri-
cator.
As mentioned before, the best option is to
install a filter/lubricator/regulator unit such
as the Grizzly Model H2333 in your air line.
Figure 5. Lubricating the nailer/stapler via
air inlet.
H2912/H2913 2-IN-1 NAILER/STAPLER
Cleaning The Nailer/Stapler
Use a good solvent to clean the nose
assembly of the nailer/stapler. Always be
sure that the nailer/stapler is dry before
using it again.
Do not allow dust, chips, sand, etc. into the
air connectors or into the body of the nail-
er/stapler; this may result in leaks and
damage to the nailer/stapler and the air
couplings.
Never use gasoline or other flamma-
ble liquids to clean this tool. Vapors
in the tool may ignite, causing the
tool to explode. Ignoring this warning
may lead to serious personal injury or
even death!
Always disconnect air from the nail-
er/stapler whenever
During maintenance, a nailer/stapler
connected to air may fire accidental-
ly, causing serious personal injury!
servicing!
-8
-