Operation; Depth Adjustment - Grizzly H2912 Instruction Manual

Loading The Nailer/Stapler
To load your nailer/stapler:
1. Disconnect the air supply from the
nailer/stapler!
2. Push the magazine latch in the direc-
tion shown in Figure 1.
Figure 1. Releasing magazine latch.
3. Pull back the magazine cover until it
stops.
4. Point the nailer/stapler up and insert a
stick of nails/staples into the maga-
zine as shown in Figure 2. Make sure
that the pointed ends of the nails/sta-
plers point in the same direction as
the Model H2912/H2913 nose and the
nails/staples rest in the slot at the bot-
tom of the magazine.
Figure 2. Loading the nailer/stapler.
H2912/H2913 2-IN-1 NAILER/STAPLER

OPERATION

5. Push the magazine cover forward
until the magazine latch locks in
place.

Depth Adjustment

1. Rotate the depth adjustment wheel
(shown in Figure 3) clockwise to
increase the nail/staple driving depth.
2. Rotate the finger wheel counter-clock-
wise to decrease the nail/staple dri-
ving depth.
Figure 3. Depth adjustment wheel.
Operating The Nailer/Stapler
If you have not read the safety instruc-
tions in this manual, do not operate the
nailer/stapler.
Before you operate your nailer/stapler,
place one drop of the included oil into the
quick connect fitting where the nailer/sta-
pler connects to the air supply. Fire the
EMPTY nailer/stapler 3-4 times before
beginning, so oil does not come out onto
the project during regular operation.
-6
-