Feed Rates
Recommended Feed Rates
Rough Cuts
Note: These values are a guideline only. Refer
to the MACHINERY'S HANDBOOK for more
detailed information.
Figure 54.
To set the feed rate:
1.
OFF
NOTICE
NEVER move levers while the lathe is run-
ning, and NEVER force any lever when shift-
ing. If the lever will not engage, rotate the
chuck by hand while keeping light pressure
on the lever. As the chuck rotates it aligns
the gears and the lever will engage.
Figure 54
Finish Cuts
2.
Figure 55.
For Example:
Figure 56.
3.
Figure 55
Figure 56