Power Feed - Grizzly G9036 Owner's Manual

13" x 40" gear-head lathe
Hide thumbs Also See for G9036:
Table of Contents

Advertisement

Power Feed

NOTICE
Feed rate is based on spindle RPM. High
feed rates combined with high spindle
speeds result in a rapidly moving carriage
or cross slide. Pay close attention to the
feed rate you have chosen and keep your
hand poised over the feed switch. Failure to
fully understand this will cause the carriage
to crash into the spindle.
Figure 51
Page 36
Figure 51.
To engage the power feed:
1.
OFF
2.
Feed Rates
3.
4.
Figure 52
Note: These instructions are valid with a
counterclockwise or forward rotation of the
spindle. All directions reverse when spindle
rotation is reversed.
Neutral
REV
Figure 52.
Figure 53
Figure 53.
FWD

Advertisement

Table of Contents
loading

Table of Contents