Table of Contents
Advertisement
Display setup interface is shown as below. See Figure 4-15.
Transparency: Here is for you to adjust transparency. The value ranges from 128
to 255.
Channel name: Here is for you to modify channel name. Please note all your
modification here only applies to DVR local end. You need to open web or client
end to refresh channel name.
Time display: You can select display time or not.
Channel display: You can select channel name or not.
Overlay information: System displays some information in the screen for your
reference.
Enable tour: activate tour function.
Interval: Input proper interval value here. The value ranges from 5-200 seconds.
In tour process, you can use mouse or click Shift to turn on window switch
function.
Stands for opening switch function,
function.
View1/4/9/16: System support 1/4/9/16 window tour.
Please highlight icon
After all the setups please click save button, system goes back to the previous menu.
4.3.10 Default
Click default icon, system pops up a dialogue box. You can highlight
default factory setup. See Figure 4-16.
Select all
General
Encode
Schedule
RS232
Network
Alarm
Detect
Pan/tilt/zoom
to select the corresponding function.
Figure 4-15
stands for closing switch
to restore
61
Advertisement
Table of Contents
