Table of Contents
Advertisement
3.6 Alarm Setup and Alarm Activation
Before operation, please make sure you have properly connected alarm devices
such as buzzer.
3.6.1 Go to alarm setup interface
In the main menu, from Setting to Alarm, you can see alarm setup interface. See
Figure 3-19.
3.6.2 Alarm setup
Alarm interface is shown as below. See Figure 3-19.
Alarm in: here is for you to set channel number.
Source of alarm: there are two alarm sources: local input or network input.
Type: normal open or normal close.
Record channel: you can select proper channel to record alarm video (Multiple
choices). At the same time you need to set alarm record in schedule interface
(Main Menu->Setting->Schedule) and select schedule record in manual record
interface (Main Menu->Advance->Manual Record).
Latch: Here is for you to set proper delay duration. Value ranges from 10 to 300
seconds. System automatically delays specified seconds in turning off alarm and
activated output after external alarm cancelled.
PTZ preset: Here is for you to activate PTZ control.
Relay out: select proper alarm activation output channel (multiple choices).
Show message: System pops up message in the screen to alert you once alarm
occurred.
Period 1 and period 2: set proper time and alarm tips.
Please highlight icon
please click save button, system goes back to the previous menu.
Figure 3-18
to select the corresponding function. After all the setups
43
Advertisement
Table of Contents
