Ptz Control And Color Setup; Cable Connection; Ptz Setup - Videovox Pro DVR User Manual

Atm series standalone dvr

Table of Contents

3.8 PTZ Control and Color Setup

Note: All the operation here is based on DH-SD protocol. For PELCO protocols,

there might be a little difference.

Please follow the procedures below to go on cable connection

Connect the dome RS485 port to DVR 485 port..

Connect dome video output cable to DVR video input port.

Connect power adapter to the dome.

Note: The camera video should be in the current screen. Before setup, please

check the following connections are right:

PTZ and decoder connection is right. Decoder address setup is right.

Decoder A (B) line connects with DVR A (B) line.

Boot up the DVR, input user name and password.

In the main menu, click setting, and then click Pan/Tilt Control button. The

interface is shown as in Figure 3-23. Here you can set the following items:

Channel: select the current camera channel.

Protocol: select corresponding PTZ protocol(such as DH-SD1)

Address: default address is 1.

Baud rate: select corresponding baud rate. Default value is 9600.

Data bits: select corresponding data bits. Default value is 8.

Stop bits: select corresponding stop bits. Default value is 1.

Parity: there are three options: odd/even/none. Default setup is none.

After all the setting please click save button.

In one window display mode, right click mouse (click "Fn" Button in the front panel

or click "Fn" key in the remote control). The interface is shown as in

Figure 3-23

Figure 3-24.

Table of Contents