Symmetricom ND-CLK User Manual page 36

If this command fails to clear an issue with the clock, a hard reset may be in order to
return the unit to its factory default state. In certain [rare] instances it may become
necessary to access the configuration reset switch to return the network clock to its
factory default settings or to recover from a non-responsive condition. Consult the section
"Reset Factory-Default Configuration" under the "Configuration" section of this manual.
Set hand pos. stepper analog clock
The ND-CLK analog stepper motor clock has a calibration feature. Use this option to
calibrate the hands of the clock to the displayed time
The ND-CLK analog clock hands have been pre-set and aligned at the factory. This hand
location and alignment information is retained in non-volatile flash. Under normal
circumstances it should not be necessary to adjust or align the hands. However, if for any
reason, the hands are not tracking the NTP source, an adjustment function has been built
into the ND-CLK and its support software.
Once you enter this mode, the hands of the analog clock will stop. Enter the correct hour,
minute, and second currently displayed on the face of the clock. If the second is not
currently aligned on a second mark, you can nudge the second hand forward
incrementally.
Get Status stepper analog clock
Provides status information specific to the analog stepper motor clock.
[Note: this menu items applies to analog stepper motor models only]
Enable/Disable User Control of Digital Display
[Note: this menu items applies to digital time display models only]
Enter X to exit the Telnet menu. This will disconnect your Telnet session from the clock.
ND-CLK User Manual- Rev 1.0.1 - Sep-08
33
®
Symmetricom , Inc