4.
5.
Figure 34
Figure 34.
6.
Figure 35
Figure 35.
Always use a low spindle speed when
machining non-cylindrical or off-center
workpieces to avoid ejecting the workpiece
from the holding device at a high rate of
speed. Failure to heed this warning could
lead to serious personal injury, death or
property damage.
Faceplate
Page 50
To mount a workpiece to the faceplate:
1.
2.
3.
Figure 36
Note: Take into account the rotation and
cutting forces that will be applied to the
workpiece when clamping it to the faceplate.
Figure 36.
ACCESSORIES