Page 1
FORCE BLOWER PUSH Owner’s Manual Patent #6,253,416 and other patents pending F902S, F902H, F1302H, F1802V BILLY GOAT FORCE BLOWER Owner's Manual Accessories HOLD DOWN KIT CASTER KIT SOLID FRONT TIRE PARKING BRAKE To secure blower for For greater Solid flat-free front tire.
FORCE BLOWER PUSH Owner’s Manual ABOUT THIS MANUAL ® THANK YOU for purchasing a BILLY GOAT FORCE Blower. Your new machine has been carefully designed and manufactured to provide years of reliable and productive service. This manual provides complete operating and maintenance instructions that will help to maintain your FORCE Blower in top running order.
FORCE BLOWER PUSH Owner’s Manual SERIAL PLATE DATA Record the model number, serial number, date of purchase, and where purchased. Purchase Date: Purchased From: Specifications F902S F902H F1302H F1802V Engine: HP 9.0 HP (6.6kW) 9.0 HP (6.6kW) 13.0 HP (9.6kW) 18 HP (13.42kW)
This symbol indicates that this manual and the engine manufacturer’s manual should be read carefully before assembling, operation, or servicing this equipment. ® This symbol indicates important information that will prevent damage to your BILLY GOAT FORCE Blower. This symbol indicates the engine oil level should be checked before operating this equipment.
Page 5
FORCE BLOWER PUSH Owner’s Manual DO NOT run this equipment indoors or in any poorly ventilated area. Refueling outdoors is recommended. DO NOT refuel this equipment while the engine is running. Allow engine to cool for at least two minutes before refueling. DO NOT store gasoline near an open flame.
FORCE BLOWER PUSH Owner’s Manual SOUND SOUND LEVEL 97 Db(a) at Operators Position 117 dB Sound tests were conducted in accordance with 2000/14/EC, as well as ISO 11094, and were performed on 12-12- 2006 under the conditions listed below. Sound power level listed is the highest value for any model covered in this manual. Please refer to serial plate on the unit for the sound power level for your model.
FORCE BLOWER PUSH Owner’s Manual INSTRUCTION LABELS ® The labels shown below were installed on your BILLY GOAT FORCE Blower. If any labels are damaged or missing, replace them before operating this equipment. Item numbers from the Illustrated Parts List and part numbers are provided for convenience in ordering replacement labels.
FORCE BLOWER PUSH Owner’s Manual ASSEMBLY 1.Follow the steps in figures A and B, then securely tighten all hardware shown. 2.Connect spark plug wire. Figure A Figure B The hardware for attaching the upper handle to the lower The throttle control will be attached to the throttle arm on is in the parts bag.
Never lift the machine while the engine is running. BLOWING OPERATION Your Billy Goat Force blower is equipped with an air director cone and the patented Aim-N-Shoot control lever to allow the operator to direct the air stream up or down as required to assist in moving debris. This feature is extremely useful when debris has piled up to the point that it cannot be blown any farther.
FORCE BLOWER PUSH Owner’s Manual ADJUSTING AIR DIRECTOR To adjust air direction, squeeze Aim-N-Shoot control lever. When you want to blow debris at the same angle for an extended period, choose a suitable position and use the finger controlled push button lock to lock the cone in position. For operations that do not require the use of the Aim-N-Shoot feature the manual adjustment knob, pictured below, can be used to permanently lock the cone into position.
FORCE BLOWER PUSH Owner’s Manual MAINTENANCE ERIODIC AINTENANCE Periodic maintenance should be performed at the following intervals: Maintenance Operation Every Daily or Every Every 25 Every 50 Every 5 Hours Hours Hours 100-150 Hours Inspect for worn or damaged parts. Check for excessive vibration Inspect Impeller for cracks or damage Inspect for loose parts.