Do you have a question about the F1002V and is the answer not in the manual?
Questions and answers
WC Graham
May 21, 2025
How do I adjust the Air Director Cone further down just a little. The Manual Adjustment Knob seems to very loose and not tighten...not sure how to use it.
Page 1
FORCE PUSH BLOWER Owner’s Manual Patent #6,253,416 and other patents pending FORCE BLOWER Owner's Manual F902H, F1002V, F1302H, F1402V, F1802V Beginning Serial #: 110215001 Accessories HOLD DOWN KIT SOLID FRONT TIRE PARKING BRAKE CASTER KIT To secure blower for Solid flat-free front tire.
FORCE PUSH BLOWER Owner’s Manual CONTENTS SPECIFICATIONS, SAFETY, AND INSTRUCTION LABELS ENGINE LABELS AND PACKING CHECKLIST_ ASSEMBLY______ OPERATION MAINTENANCE AND TROUBLESHOOTING _ MAINTENANCE RECORD___________ ILLUSTRATED PARTS AND PARTS LISTS __ 9-11 Part No 440313 440313_E_HI...
INSTRUCTION LABELS ® The labels shown below were installed on your BILLY GOAT FORCE Blower. If any labels are damaged or missing, replace them before operating this equipment. For your convenience in ordering replacement labels, part numbers are included in the Illustrated Parts List.
® These items should be included in your carton. If any of these parts are missing, contact your dealer. Your BILLY GOAT FORCE Blower was shipped in one carton, completely assembled except for the Upper Handle Assembly and Front Diverter.
FORCE PUSH BLOWER Owner’s Manual ASSEMBLY 1. The hardware for attaching the upper handle to the lower is in the parts bag. Install upper handle (item 30), to preassembled lower handle (item 28) by sliding the upper handle over and down the outside of the lower handle. Using the bolts (items #36 and #71), washers (item #10) and lock nut (item #11) to install upper handle to lower handle.
FORCE PUSH BLOWER Owner’s Manual OPERATION BLOWING OPERATION Your Billy Goat Force blower is equipped with an air director cone and the patented Aim-N-Shoot control lever to allow the operator to direct the air stream up or down as required to assist in moving debris. This feature is extremely useful when debris has piled up to the point that it cannot be blown any farther.
FORCE PUSH BLOWER Owner’s Manual MAINTENANCE PERIODIC MAINTENANCE Periodic maintenance should be performed at the following intervals: Maintenance Operation Every Use Daily or Every 5 Hours Every 100-150 Hours Inspect for worn or damaged parts Check for excessive vibration ...
FORCE PUSH BLOWER Owner’s Manual FORCE PUSH PARTS DRAWING Part No 440313 440313_E_HI...
Page 10
FORCE PUSH BLOWER Owner’s Manual FORCE PUSH PARTS LIST F1302H F1402V F902H F1002V F1802V ITEM NO. DESCRIPTION PART NUMBER QTY. PART NUMBER QTY. PART NUMBER QTY. PART NUMBER QTY. PART NUMBER QTY. ENGINE 13 HP HONDA GX390UT2 QA2 430366 ENGINE, VANGUARD 400...
Page 11
FORCE PUSH BLOWER Owner’s Manual F1302H F1402V F901H F1002V F1801V ITEM NO. DESCRIPTION PART NUMBER QTY. PART NUMBER QTY. PART NUMBER QTY. PART NUMBER QTY. PART NUMBER QTY. SADDLE UPPER DIVERTER 440114 440114 440114 440114 440114 SCREW PLASTITE #10-14 X 1"...
Need help?
Do you have a question about the F1002V and is the answer not in the manual?
Questions and answers
How do I adjust the Air Director Cone further down just a little. The Manual Adjustment Knob seems to very loose and not tighten...not sure how to use it.