Page 1
FORCE SP BLOWER Owner’s Manual Patent #6,253,416 and other patents pending FORCE BLOWER Owner's Manual F1002SPV, F1302SPH, F1402SPV, F1802SPV Beginning Serial #: 110215001 Accessories HOLD DOWN KIT SOLID FRONT TIRE PARKING BRAKE CASTER KIT To secure blower for Solid flat-free front tire.
FORCE SP BLOWER Owner’s Manual CONTENTS SPECIFICATIONS, SAFETY, AND INSTRUCTION LABELS ENGINE LABELS AND PACKING CHECKLIST ASSEMBLY_________ OPERATION MAINTENANCE TROUBLESHOOTING_______ _____ _____9 MAINTENANCE RECORD____________ ILLUSTRATED PARTS AND PARTS LIST _______________11-13 Go to http://www.billygoat.com for French-Canadian translations of the product manuals. Visitez http://www.billygoat.com pour la version canadienne-française des manuels de...
For more information go to www.P65Warnings.ca.gov. INSTRUCTION LABELS ® The labels shown below were installed on your BILLY GOAT FORCE Blower. If any labels are damaged or missing, replace them before operating this equipment. For your convenience in ordering replacement labels, part numbers are included in the Illustrated Parts List.
These items should be included in your carton. If any of these parts are missing, contact your dealer. ® Your BILLY GOAT FORCE Blower was shipped in one carton, completely assembled except for the Upper Handle Assembly and Front Diverter. Mounting hardware for the Upper Handle Assembly can be found in the parts bag.
FORCE SP BLOWER Owner’s Manual ASSEMBLY The hardware for attaching the upper handle to the lower is in the parts bag. Install the upper handle (item 30), to preassembled lower handle (item 28) by sliding the upper handle over and down the outside of the lower handle. Using the bolts (items #36 and #123), washers (item #10) &...
This type of failure will void the manufacturer’s warranty. BLOWING OPERATION Your Billy Goat Force blower is equipped with an air director cone and the patented Aim-N-Shoot control lever to allow the operator to direct the air stream up or down as required to assist in moving debris.
FORCE SP BLOWER Owner’s Manual MAINTENANCE PERIODIC MAINTENANCE Periodic maintenance should be performed at the following intervals: Maintenance Operation Every Use Daily or Every 5 Hours Every 100-150 Hours Inspect for worn or damaged parts Check for excessive vibration ...
Page 8
FORCE SP BLOWER Owner’s Manual BELT REPLACEMENT 1. Wait for engine to cool and disconnect spark plug. 2. Follow the impeller removal steps (2-5 on page 8). 3. Remove the four bolts (item #8) holding the back plate (item 4) to the back housing (item #6).
FORCE SP BLOWER Owner’s Manual TROUBLESHOOTING Problem Possible Cause Solution Abnormal vibration Loose or out of balance impeller. Check impeller and replace if required. Debris in impeller. Clear debris with compressed air or a backpack blower (see Fig . 8 and 9 below).* Loose engine.
FORCE SP BLOWER Owner’s Manual FORCE SP PARTS DRAWING Part No 440314 440314_G_HI...
Page 12
FORCE SP BLOWER Owner’s Manual FORCE SP PARTS LIST F1302SPH F1402SPH F1002SPV F1802SPV ITEM NO. DESCRIPTION PART NUMBER QTY. PART NUMBER QTY. PART NUMBER QTY. PART NUMBER QTY. ENGINE 13 HP HONDA GX390 440018 ENGINE, VANGUARD 400 440346 ENGINE 10HP VANGUARD...
Page 13
FORCE SP BLOWER Owner’s Manual FORCE SP PARTS LIST F1302SPH F1402SPH F1002SPV F1802SPV ITEM NO. DESCRIPTION PART NUMBER QTY. PART NUMBER QTY. PART NUMBER QTY. PART NUMBER QTY. PIN CLEVIS 1/4 X 3/4 440124 440124 440124 440124 HITCH PIN CLIP .051 X 3/4"...