Assembly Instructions - Stamina 1205 PRECISION ROWER Owner's Manual

ASSEMBLY INSTRUCTIONS

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please
call our toll-free number for assistance 1 (800) 375-7520 or e-mail us at:
STEP 1
PEDAL SHAFT(15)
Insert the
SPACER(16)
a and a
CENTER BEAM(1).
(M10)(36), ACORN NUTS(M10)(33)
and
NOTE: You need to use two Wrenches to tighten the
PEDAL SHAFT(15)
STEP 2
PEDAL STRAPS(18)
Insert the
PEDALS(17),
the ends of the
as shown above.
parts@staminaproducts.com
through holes located on the front end of the
PEDAL(17)
onto each end of the
PEDALS(17)
Then secure the
at the same time.
into the slots in the bottom of the
PEDAL STRAPS(18)
PEDAL SHAFT(15)
WASHERS(M10)(38), LOCK WASHERS
with
PEDAL SHAFT(15).
at both sides of the
ACORN NUTS(M10)(33)
will be facing away from the
6
CENTER BEAM(1).
and slide them toward the
at both ends of the
PEDALS(17).
When feet are in the
CENTER BEAM(1)
Place