Using The Electronics Meter - Stamina 1205 PRECISION ROWER Owner's Manual

USING THE ELECTRONICS METER

POWER ON : Seat movement or push the BUTTON.
POWER OFF :
Automatic shut off after 4 minutes of inactivity.
FUNCTION BUTTON:
Press the button to select functions. Reset all functions to zero
by pressing the button and holding it down for four seconds.
FUNCTION MARKS ( On The Display ) :
A : Scan
S : Speed
D : Distance
T : Timer
FUNCTIONS:
SCAN:
Press the button until "A" appears in the display. Automatically scans SPEED, DISTANCE,
TIMER, COUNT, and CALORIE in sequence with change every 4 seconds.
SPEED:
Press the button until "S" appears to display the current speed, from zero to 71 MPH.
DISTANCE:
Press the button until "D" appears to display the distance you are traveling, from zero to
999.9 miles.
TIMER:
Press the button until "T" appears to display the rowing time, from 1 sec up to 99:59 minutes.
COUNT:
Press the button until "CO" appears to display the total number of rows you have taken,
from zero to 9999 rows.
CALORIE:
Press the button until "CA" appears to display the calorie consumption, from zero to 999.9
K cal.
The calorie readout is an estimate for an average user. It should be used only as a comparison
between workouts on this unit.
HOW TO INSTALL AND REPLACE BATTERY:
1. Use hand or simple tool to pry the METER(39) from the
CONSOLE(40).
2. The meter operates with an AA battery. Refer to the illustration to
install or replace the battery.
NOTE:
1. Rechargeable batteries are not recommended.
CO : Count
CA : Calories
M : Mile
Signal Mark
:
10
AA Battery