Stamina 1205 PRECISION ROWER Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 5:
Attached the
FRAME(2) BOLT(M8 x 55mm)(30), NYLOCK NUT(M8)(32),
with
STEP 6:
Attach the
BOLT(M8 x 40mm)(29), NYLOCK NUT(M8)(32),
with
assembled the shock allowing the shock to extend toward the
SHOCK(11)
of the
NUT(M8)(32),
and WASHER(M8)(37).
NOTE: 1.
Repeat the above to assemble the
RIGHT BASE FRAME(3).
2. The resistance of the shocks can be adjusted by sliding the
change the position on the
resistance, the upper position will provide the higher resistance.
LOCKING KNOBS(10)
Tighten
3.
CAUTION: The shocks get HOT after a few minutes of use.
STEP 7:
Slide the
CENTER BEAM(1)
the
STOPPER BOLT(14)
the other
CENTER BEAM(1).
the back end of the
LEFT HANDLEBAR(5)
SHOCK(11)
onto the bracket located on the front of the
TENSION ADJUSTER(9)
to the
HANDLEBARS.
SEAT(19) CENTER BEAM(1).
onto the
and lock in position by screwing on the
is assembled at the factory. Press the
onto the bracket located on the rear of the
and
HANDLEBAR(5).
BOLT(M8 x 40mm)(29), NYLOCK
with
RIGHT HANDLEBAR(6)
The lowest position will provide the lowest
securely before using the
Insert the
STOPPER(13).
8
WASHER(M8)(37).
and
LEFT BASE FRAME(2)
WASHER(M8)(37).
Connect the other end
SHOCK(11)
and
TENSION ADJUSTERS
1205 PRECISION ROWER.
STOPPER BOLT(14)
Also, please verify that
CENTER BEAM CAP(22)
LEFT BASE
Mask sure you
to the
to
through
into