ITEM
Setting Mode
(Time Switch)
Exit Setting Mode
5-3. Odometer
ITEM
Operation Features
Units Switch
DESCRIPTIONS
+
Press
the backlight illuminates in the meantime.
1) When "Hour" digit is flashing, press
then press
2) When "Min" digit is flashing, press
back to "Hour" setting mode.
press
If press
for longer than 2 seconds, the number will increase
continually till the button released.
The setting value runs cyclically ( only 2 sec. from 0 to 9)
Under Setting-Mode, when
1) idle for longer than 20 seconds
+
2) press
the system will save the last setting value automatically and back to
Working-Mode.
DESCRIPTIONS
OptoCoupler sensor detects the signal and then converts into a distance value.
When speedometer was set as
「km/h」, the odometer displays as kilometer.
「mph」, the odometer displays as mile.
「/h」, means the odometer is displaying as travel hours.
for longer than 2 seconds to enter Setting-Mode,
to increase the number, and
into "Min" setting mode.
to increase the number, then
for longer than 2 seconds,
17