Irc (Infrared Remote Control) Operation - Chauvet COLORrail IRC IP User Manual

IRC (Infrared Remote Control) Operation

Note: Make sure to point the IRC directly at the receiver on the product.
COLORrail™ IRC IP User Manual (Rev. 3)
Automatic Mode
Automatic Mode will enable you to run the automatic programs on the
product.
To turn on Automatic Mode:
1. Press AUTO on the IRC.
2. Press + or – to choose between the different auto programs.
To adjust the speed of the automatic program:
1. Press SPEED on the IRC.
2. Press %.
3. Press + or – to either increase or decrease the speed of the program.
Sound Active Mode (if available)
Sound Active Mode will enable the product to respond to the music.
To turn on Sound Active mode:
1. Press SOUND on the IRC.
To adjust sound sensitivity in Sound Active mode:
1. Press SENSITIVITY on the IRC.
2. Press %.
3. Press + or – to either increase or decrease sound sensitivity.
Manual Color Control
To choose a specific color with the IRC:
1. Press MANUAL on the IRC.
2. Press any number between 0-9 to choose your color.
To manually control the RGB percentage:
1. Press MANUAL on the IRC.
2. Press R, G, or B to choose your color.
3. Press + or – to increase or decrease the percentage of each color.
Miscellaneous Operation
To adjust the strobe rate of the program:
1. Press STROBE on the IRC.
2. Press + or – to increase or decrease the strobe rate.
3. Press STROBE again to turn off the strobe.
To change the switching effect of the program:
Press FADE/SNAP on the IRC.
Fade will slowly switch the effect. Snap will rapidly switch the effect.
To black out the lights:
Press BLACK OUT on the IRC.
This will turn off all the lights until the button is pressed again.
Note: The IRC will not respond to any inputs when Black Out is activated. If
the remote does not respond when a button is pressed, try pressing
BLACK OUT. You may have inadvertently activated BLACK OUT.
Page 13 of 16