Configuration (Dmx); Configuration (Standalone Modes) - Chauvet Intimidator Wash LED 150 User Manual

Configuration (DMX)

Starting Address

Configuration (Standalone Modes)

Sound Active Mode
Automatic Mode
Intimidator™ Wash LED 150 User Manual (Rev. 02)
Set this product in DMX mode to control it with a DMX controller.
1) Connect this product to a suitable power outlet.
2) Turn this product on.
3) Connect a DMX cable from the DMX output of the DMX controller to the DMX
input socket of this product.
When selecting a starting DMX address, always consider the number of DMX
channels the selected DMX mode uses. If you choose a starting address that is too
high, you could restrict the access to some of the fixture's channels.
The Intimidator™ Wash LED 150 uses up to 15 DMX channels in the advanced
personality, which defines the highest configurable address to 497.
If you are not familiar with the DMX protocol, you may refer to the "DMX Primer"
section in the "Technical Information" chapter.
To select the starting address, do the following:
1) Press <MODE/ESC> repeatedly until d*** shows on the display.
2) Press <ENTER>.
3) Use <UP> or <DOWN> to select the starting address.
4) Press <ENTER>.
Set this product in one of the standalone modes to control it without a DMX controller.
1) Connect this product to a suitable power outlet.
2) Turn this product on.
To enable the Sound Active mode, do the following:
1) Press <MODE/ESC> repeatedly until one of the following shows on the display:
NASL, NAFA, NStS, SLAU.
2) Use <UP> or <DOWN> to select NStS.
3) Turn the music on.
4) Press <ENTER>.
The fixture will only respond to the low frequencies of the music (bass and
drums).
Never connect a fixture that is operating in any standalone mode, whether
Static, Automatic, or Sound to a DMX string connected to a DMX controller.
This is because fixtures in standalone mode may transmit DMX signals that
could interfere with the DMX signals from the controller.
To enable the Automatic Mode, follow the instructions below:
1) Press <MODE/ESC> repeatedly until one of the following shows on the display:
NASL, NAFA, NStS, SLAU.
2) Use <UP> or <DOWN> to select NAFA (fast) or NASL (slow).
4) Press <ENTER>.
Page 11 of 20