General Troubleshooting - Chauvet Intimidator Wash LED 150 User Manual

General Troubleshooting

Page 16 of 20
Symptom

Excessive load on the circuit
Circuit breaker
or fuse keeps
blowing

Short circuit along the power
lines

No energy on power outlet

Loose or damaged power cord
Product does not
power up

Blown fuse

Internal problem

Wrong starting address on the
fixture

Wrong DMX personality on the
fixture
Fixture does not
respond to DMX

Wrong operating mode set on
the fixture

Loose or damaged DMX cable

Internal problem

Signal cables are not DMX
compatible

Interference with AC or radio
signals

DMX cable too long
Intermittent DMX
Problems

Too many fixtures connected

Terminator not connected
If you still experience problems after trying the above solutions, contact
CHAUVET® Technical Support.
Possible Cause



















Intimidator™ Wash LED 150 User Manual (Rev. 02)
Possible Action
Make sure that the total load
does not exceed 80% of the
breaker or fuse nominal current
Check the power lines and
power cords
Check power outlet
Change to another outlet
Check the power cord
Replace blown fuse with a good
one of the same type and rating
Send product for repair
Set the correct starting address
on the fixture
Use the right fader(s) on the
controller
Set the correct DMX fixture's
personality
Assign the faders accordingly
Change the fixture settings
Check the DMX cable before
the faulty unit
Send product for repair
Replace non DMX cables with
true DMX cables
Keep DMX cables away from
AC wires or radio equipment
Install an optically coupled DMX
amplifier right before the fixture
with intermittent problems
Install an optically coupled DMX
amplifier after unit #32
Install a terminator, as indicated
in the "DMX Primer" section.