Glass Assembly; Screen Mesh; Air Shutter Setting - Heat & Glo Escape-42DV Owner's Manual

F. Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door removed,
cracked, broken or scratched.
• Replace glass door assembly as a complete
appliance.
Removing Glass Assembly
• Remove the ash lip that is located in front of the glass.
• Remove the side panels located in front of the glass.
• Remove the pull mesh firescreen by unhooking from the
fireplace.
• Pull and release the six glass latches (3 per side) lo-
cated on the sides of the glass frame.
• Grasping the upper lip with one hand and the lower lip
with the other, pull the bottom of the glass out first. Guide
the bottom while letting the top drop down under the top
(see Figure 12.13).
of the opening
Replacing Glass Assembly
Replace the glass door on the appliance. Pull out and latch
the six glass assembly latches into the groove on the glass
frame.
GLASS
CLIP
Figure 12.13

Glass Assembly

36
UPPER
LIP
Heat & Glo • Escape-42DV • 2052-900 Rev. B • 5/05
G. Screen Mesh
The pull-type firescreen hangs on the three hanger brackets
located above the glass.
H. Air Shutter Setting
This appliance has an adjustable air shutter (which controls
the primary air) factory set for the minimum vertical vent
run. If your installation has more than the minimum required
vertical vent length, adjustment of the air shutter may be
necessary to obtain optimal flame appearance. This should
be adjusted by a qualified installer at the time of
installation.