Electrical Information; Recommendation For Wire; Section 10: Electrical Information A. Recommendation For Wire; Connecting To The Appliance - Heat & Glo Escape-42DV Owner's Manual

10

Electrical Information

A. Recommendation for Wire
This appliance requires 110-120 VAC be wired to the factory
installed junction box.
NOTE: This appliance must be electrically wired and
grounded in accordance with local codes or, in the absence
of local codes, with National Electric Code ANSI/NFPA 70-
latest edition or the Canadian Electric Code, CSA C221.1.
B.

Connecting to the Appliance

WARNING
Wire 110V to electrical junction box.
Do NOT wire 110V to valve.
Do NOT wire 110V to wall switch.
• Incorrect wiring will damage millivolt valves.
• Uninterrupted or continuous power is
required at all times in IPI system.
• Incorrect wiring will override IPI safety
lockout and may cause explosion.
This appliance comes standard with a multi-junction wall
switch, installed in the unit.
Follow the "Determine Location" and "Wiring the Wall
Switch" sections of the instructions included with the WSK-
MLT box.
Install the flame control solenoid by following Steps 5 - 11
in the "Installing the Control Box" section of the instruc-
tions included with the WSK-MLT box.
Also carefully follow the "Setting Flame Height/Manifold
Pressure" section of the included instructions to properly
set the valve pressure. Operating instructions are also in-
cluded in the WSK-MLT instructions.
Heat & Glo • Escape-42DV • 2052-900 Rev. B • 5/05
C. Intellifire Ignition System Wiring
This appliance requires a 110 VAC supply to the appliance
junction box for operation. A wiring diagram is shown in
Figure 10.2.
This appliance is equipped with an Intellifire control valve
which operates on a 3 volt system.
It is highly recommended that the junction box be installed
at this time to avoid reconstruction.
Optional Accessories Requirements
Wiring for optional accessories should be done now to
avoid reconstruction.
27